Pelco C554M Manual do Utilizador

®CM9760-IRCInfrared VCRControllerInstallation/Operation ManualC544M (2/98)Pelco • 3500 Pelco Way, Clovis • CA 93612-5699 USA • www.pelco.comIn North

10 Pelco Manual C544M (2/98)3.3 CONNECTING THE CM9760-IRC TOTHE CM9760-CC1 HOSTEach CM9760-IRC has two RS-422 ports; one labeled IN (male) and the oth

Pelco Manual C544M (2/98) 113.3.1 Connecting the CM9760-IRC to a CM9760-CC1 Hostvia Serial GPIA CM9760-IRC can be daisy-chained from a serial GPI alre

12 Pelco Manual C544M (2/98)3.5 CONNECTING VCRs TO THE VIDEO MATRIX BAY(CM9760-MXB)VCRs must be connected to the CM9760-MXB (Video Matrix Bay). Two st

Pelco Manual C544M (2/98) 133.6 VCR CONTROL SIGNAL OUTPUTSAn IRC has up to 32 D9 female output connections numbered J1 to J32, each ableto control fo

14 Pelco Manual C544M (2/98)4.0 SPECIFICATIONSElectrical SpecificationsOperatingVoltages: 120 or 230 VAC 50/60 Hz.±10%, selectablePowerConsumption: 1

Pelco Manual C544M (2/98) 15NOTES

16 Pelco Manual C544M (2/98)5.0 WARRANTY AND RETURN INFORMATIONPelco, the Pelco logo, Camclosure, Esprit,Genex, Legacy, and Spectra are registeredtra

2 Pelco Manual C544M (2/98)CONTENTSSection Page1.0 GENERAL ...

Pelco Manual C544M (2/98) 3Please thoroughly familiarize yourself with the informationin this manual prior to installation and operation.1.0 GENERAL1

4 Pelco Manual C544M (2/98)2.0 DESCRIPTIONThe Pelco 9760-IRC VCR Controller provides remote control of most VCRsequipped with an infrared receiver fo

Pelco Manual C544M (2/98) 52.1 GENERAL FEATURESThe Pelco 9760-IRC is housed in a rack frame and connects to one Sercom port onthe rear of the CM9760-

6 Pelco Manual C544M (2/98)2.2 SAMPLE SYSTEMA typical system installation involving the CM9760-IRC might include:a. CM9760-CC1 e. Monitorsb. CM9760-I

Pelco Manual C544M (2/98) 73.0 INSTALLATIONTo install the Pelco Infrared VCR Controller, proceed as follows:1. Set the baud.2. Set the start address.

8 Pelco Manual C544M (2/98)3.1.1 Setting the BaudBauds of 2400, 4800, 9600, and 19200 are available. The communication protocoluses eight data bits,

Pelco Manual C544M (2/98) 93.2.1 Setting the Start AddressEach Pelco CM9760-IRC unit requires a six-bit start address. The start address isconfigured